A small bali on ball bearing
Closed 11cm, width 2,8 cm to the heel, thickness 9mm to the pivot.
Open 18,7 cm, sharp 6,5 cm, blade thickness 3mm, xc75 oil hardening, flash tempering.
Ta6v4 handle, heat anodised.
3" ti balisong
Moderator: The Motley Crew
Forum rules
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
- cardoso5fr
- Posts: 1140
- Joined: Fri Jun 02, 2006 1:30 pm
- Contact:
- Vagrant
- Self Appointed Authority
- Posts: 25715
- Joined: Fri May 24, 2002 10:07 am
- Location: Live Free or Die
- Contact:
Re: 3" ti balisong
Very nice
Re: 3" ti balisong
It's always a pleasure to view your work,THANKS
EVERY MAN DIES : NOT EVERY MAN REALLY LIVES.
-
- Posts: 217
- Joined: Wed Oct 08, 2008 7:44 pm
- Location: Land of Entrapment (NM)
Re: 3" ti balisong
I've been in this hospital for over the last 6 months, so I haven't been able to get on here.
Right before I jot sick I was collecting butterfly knifes. Seeing those two, really made my day.
Thankyou for sharing them with use all. I really like the small one, I love the dagger blade.
Thanx again, Mike
Right before I jot sick I was collecting butterfly knifes. Seeing those two, really made my day.
Thankyou for sharing them with use all. I really like the small one, I love the dagger blade.
Thanx again, Mike
- cardoso5fr
- Posts: 1140
- Joined: Fri Jun 02, 2006 1:30 pm
- Contact:
Re: 3" ti balisong
Thank you very much for the kind word
Re: 3" ti balisong
Your balisong are getting better and better. Did you use the Terry Guinn tutorial for that one?
- cardoso5fr
- Posts: 1140
- Joined: Fri Jun 02, 2006 1:30 pm
- Contact:
Re: 3" ti balisong
Thank you. I used terry guinn tutorial for my first one. But as i did more or less 100 balisong now, i don't need really a tutorial now
I write 2 or three myself
I write 2 or three myself