Hey, so I recently bought a Cobra USA Balisong, I believe it's called a "Skeptic" on Bladeplay, though the box said X-29.
On bladeplay, it said the Bali was able to disassemble, but so far, I can't seem to remove the two pivot screws, since I want to add Loctite and loosen the grip a little bit (the handles are a bit tight and make a slight squealing noise.) The two screws are torx, I have been using a torx 10 with an electric screwdriver, but have had it on super low power, so it turns very slowly. It seems that when I drill one side of the screw, the other side turns as well, since it has screws on both sides.
Adjusting a Cobra USA knife...
Moderator: The Motley Crew
Forum rules
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
- Vagrant
- Self Appointed Authority
- Posts: 25715
- Joined: Fri May 24, 2002 10:07 am
- Location: Live Free or Die
- Contact:
Re: Adjusting a Cobra USA knife...
If, the other side is a torx you need to hold it still with another driver