Adjusting a Cobra USA knife...

[Rszdemon]

Hey, so I recently bought a Cobra USA Balisong, I believe it's called a "Skeptic" on Bladeplay, though the box said X-29.
On bladeplay, it said the Bali was able to disassemble, but so far, I can't seem to remove the two pivot screws, since I want to add Loctite and loosen the grip a little bit (the handles are a bit tight and make a slight squealing noise.) The two screws are torx, I have been using a torx 10 with an electric screwdriver, but have had it on super low power, so it turns very slowly. It seems that when I drill one side of the screw, the other side turns as well, since it has screws on both sides.

[Vagrant]

If, the other side is a torx you need to hold it still with another driver